revit mep 2008 - my 1st rme plumbing project   CADclips now offers you and your staff one stop shopping for all your REVIT education. REVIT Architecture, Structure and now the Plumbing series. The best news is, as expected, the RME plumbing tools work just like the HVAC tools but with pipes. It’s all about the pipe type, connectors, elevation offset, slope and diameter. I’ll show you how to place the plumbing fixtures and then ‘join the dots’ with sanitary, hot and cold water pipes. Done and done. Don’t forget to visit the Autodesk website for a truck load of additional RME Content Extensions. CADclips Login required to access these lessons. Lesson 1: RME Introduction Lesson 2: Interface and General Operations Lesson 3: Loading Plumbing Components Lesson 4: Pipe Types and Properties Lesson 5: Placing Plumbing Fixtures Lesson 6: Sanitary System Setup Lesson 7: Sanitary System - Part 1 Lesson 8: Sanitary System – Part 2 Lesson 9: 3D Plumbing Views and View Templates Lesson 10: Connecting the Sinks to Sanitary System – Part 1 Lesson 11: Fun with 3D Piping Lesson 12: Connecting the Sinks to Sanitary System – Part 2 Lesson 13: Connecting the Sinks to Sanitary System – Part 3 Lesson 14: Connecting the Sinks to Sanitary System – Part 4 Lesson 15: Refining the Waste Stack Lesson 16: Refining the Urinal Lines Lesson 17: Adding in Plumbing Vents Lesson 18: Domestic Cold Water and Setup Lesson 19: Domestic Cold Water Piping Lesson 20: Domestic Hot Water Piping